Demountable camper group

All look ok I'll see what happens overnight

thanks for the pictures great help glad it went well

Typically Tony, they don't cause any problems,
but because you have to remove the rubber bump stops on axle case (and those sometimes need an air tool or even heat to loosen them) otherwise it would be a DIY job definitely.

The hardest part of the job was to undo the ubolts but I sprayed WD40 on and wire brushed the threads then sprayed again and cleaned with an old tooth brush.

Wasn't too bad with a impact socket and a breaker bar.

surfglobe wrote:thanks for the pictures great help glad it went well

Are yours the same or different?

The pressures are the same this morning so that's another job off the list.